These forums are read only, please use our new forums here.

Main :: DT50/DT25



DT25 in Standby mode
by danievanderwalt on 2012-12-25 08:28:05

I am using the DT25 connected to a G-system using the 4CM. The FX-loop system is working in FPM and LVM when the amp is not in Standby mode. However my objective is to use the direct-out into a mixer so that I can use headphones in silenct mode. The problem I experience is that the FX-loop is disconnected when in LVM and Standby mode. Is this related to the direct output configuration of the DT25 or can this be overcome by a diffrent cabling method. I have searched the forum for this particular question but could not find any information. I will appreciate if anyone can give assistance.

Danie

Maybe a Line6 expert can reply, I simply want to now if the FX loop is active when the DT25 is in LVM and standby.

Regards

Danie




The information above may not be current, and you should direct questions to the current forum or review the manual.