These forums are read only, please use our new forums here.

Main :: Vetta



Using TC Electronics G-Force with Vetta II
by Lemec on 2013-01-10 15:48:55

I have both...Trying to use them together via the effect loops. Have the 2 "Y" cables ...but...TC G-Force get signal but no sound return to the vetta II.

When i route the loop in parallel i get the dry sound again but no fx from teh TC G-Force...

Any ideas/comments regarding this issue ?

Thank you in advance,

Best regards,

Lemec



Re: Using TC Electronics G-Force with Vetta II
by DickFoster on 2013-01-11 09:35:03

Both channels? If you're sure signal is going in on both channels then I'd first check the input jack to ensure that it is letting the FX Ret Sense line go high to the DSP, you should get about 3.3V at the junction of R37,R63 and C96 which is the sense pin on the jack. If thats OK, next I check the buffer amp outputs U10 pin 1, right and pin 7, left channel for signal. Next would be the analog to digital converter chip U16 and the signals it needs to function.



Re: Using TC Electronics G-Force with Vetta II
by Lemec on 2013-01-13 04:21:22

Thank you for the quick reply.

I connected the outs of the TC to a phones pre-amp and i do get sound (altho VERY low signal).

Does this info helps in you helping me ?



Re: Using TC Electronics G-Force with Vetta II
by DickFoster on 2013-01-13 14:21:27

If the amp you're using with headphones is supposed to be able to produce normal volumes with a standard guitar input then your pedal seems to have a problem. So I'd look there first. Is there anything else you can test the FX loop with that is known to be working as it should. See if you can borrow something if necessary. 




The information above may not be current, and you should direct questions to the current forum or review the manual.