These forums are read only, please use our new forums here.

Main :: DT50/DT25



Cut out on one patch but not other(s)
by tdownerd on 2013-01-12 19:49:13

I will preface this with the fact that I need to do some more troubleshooting but wanted to see if anyone has had this happen.

Last night at rehearsal I was using same preset most of the night on my PODHD500 into my DT25 via iLink.  Towards the end (approx. 2 hrs in)...I switched to another preset and noticed some intermittent volume cut outs.  Went back to other preset...no cut outs..repeated and just the one preset would cut out - which it's never done before.

One item of note:  First preset was on Topology 3...Preset that cut out was #4.

thoughts and input welcome

thanks,

Todd



Re: Cut out on one patch but not other(s)
by Krontab on 2013-01-13 05:24:46

I've had wierd things happen when I'm patch switching in HDedit. I just have to reboot the POD to fix the issue. I have not had your specific issue. In the topology switch did class or mode change? Typically voicing 3 is run Class A and 4 is run Class A/B. Class A is not effected by tube bias where Class A/B is. Maybe the tubes are going or the bias needs to be reset.




The information above may not be current, and you should direct questions to the current forum or review the manual.