These forums are read only, please use our new forums here.

Main :: POD HD


Support forums for all POD HD products


HD500 Stereo mixer direct issue
by mikeynez on 2013-01-20 13:39:17

I have just aquired an HD500 to upgrade from my older POD 2.0 but I am finding the POD 2.0 is kicking its ass!. I cannot get stereo output when plugging into my mixing desk using the unballanced left and right, in the same way I did with the POD 2.0. I was assuming this would be fairly easy. All the firmware updates have been done so I am up to date.

Is their anything else I need to do other than set to output to direct?



Re: HD500 Stereo mixer direct issue
by CairnsFella on 2013-01-29 22:55:32

Sorry youve had no assistance so far.

However, could you paerhaps expand upon your meaning when you say "cannot get stereo output".

for example, are you saying you are only getting output from one channel?, or perhaps that you are saying you are not getting a stereo 'effect' where you expect one.

Either way, a little more description may assist in getting your answer.




The information above may not be current, and you should direct questions to the current forum or review the manual.