These forums are read only, please use our new forums here.

Main :: DT50/DT25



Question using HDEdit
by cwatsn2 on 2013-02-11 10:41:00

Hello everyone

I am using a 500 thru the DT25.

When I am editing a new tone, adding or moving effects in the FX chain, why does it kick the amp model I have selected off, going to CHB on the DT.  This happens is before and after the mixer.  I am using the HD500 Edit software.



Re: Question using HDEdit
by spaceatl on 2013-02-11 10:47:23

Just a guess, but sometimes an FX block might have it's ON/OFF assigned to the same FS as the AMP block...It could be mutually exclusive (FX Block ON;AMP Block OFF) or synchronized(FX Block ON;AMP Block ON)...To eliminate the possibility, set the AMP Block FS to none...



Re: Question using HDEdit
by cwatsn2 on 2013-02-11 17:03:47

Thanks, I will try that.




The information above may not be current, and you should direct questions to the current forum or review the manual.