These forums are read only, please use our new forums here.

Main :: POD HD


Support forums for all POD HD products


output question
by guitarboy_02451 on 2013-02-15 12:52:09

POD HD 500 running 2.1

Is it possible to edit the position of output to place it before an amp?

Example:
- 1/4" L&R go direct to board (post amp and effects)

- Have an XLR output go to the board direct prior to going through any amps or effects.

In other words, print the post amp/fx sound, but also take a dry track pre amp/fx.

Thanks!



Re: output question
by PremiumJones on 2013-02-15 13:07:06

Nope.

You can do some sort of similar things with the FX loop block though... might wanna look into that.



Re: output question
by BlueViolince on 2013-02-15 15:47:41

If you are wanting to record dry and clean tones, try recording with the amp and post amp effects turned off.  Then run the recorded track through the Pod again, turning on only the pre-amp effects. 




The information above may not be current, and you should direct questions to the current forum or review the manual.