JacobusTracks

On 4/24/2019 at 5:04 PM, Kilrahi said:

 

As Datacommando indicated above, the manual actual shows an easy way to do it by utilizing the "Send Left" FX block and placing it just before the cab/IR block on your signal chain.  

 

The downside of this is obvious, it uses up one of the Stomp's precious six blocks.  It would be a god send if they would design the Stomp so that you could create a path B signal chain without using a block, but unfortunately that isn't the case. Still, you should be aware that another option would be to create a path B and have it go out the "send" output on path B to your power amp. Sometimes utilizing an additional delay, or a reverb, or even just a low DSP usage EQ or compressor on a path B can be more useful to your signal chain than a simple FX send block.

Thanks guy's! 

Would i still be able to create 2 signal paths?

I want to create 1 signal path distorting the high frequencies and another signal path compressing the low frequencies.  Which then come together in the amp/cab sim. And then after that go to my amp without cab/amp sim and to FOH with cab/amp sim.

So it should look like this:

                                                      ------------------------------------------->RealAmp       

Signal ----  >High's freqs/distortion/-------------------->Ampsim/cabIR------------> FOH

                   >Low freqs/compression/------^     

Is this possible? Hope you understand what im trying to explain.... 

Thanks again!

Hello,

I was wonderwing if with the HX Stomp i can get 1 signal chain with effects/amp modeling/IR impulse to go to the FOH, and a second signal with just effects/amp modeling to my power amp and cab (so without IR impulse).

Thanks in advance!!

Greetz

Wouter