ohaas

Hi, it's been a while since I used my POD Studio UX2. About a year or so ago I used POD Farm 2.01 on Win 7 without a problem (including my model packs Metal Shop, etc.). Now I wanna use the UX2 under Win 10, but the License Manager and POD Farm 2 are messed up. I tried everything mentioned in the forums and knowledge base as far as I can see, including - Clean deinstall / install with provided tools of drivers etc. - Different versions of POD Farm (2.01 and 2.59) - Different cables, USB ports, computers, etc. It usually goes something like - Installing - POD Farm complains UX2 and PC need to be authorized - Go to Licence manager and authorize - Half way through the authorization of the UX2 POD Farm 2 is listed in italic as a factory add-on - When the authorization finishes the POD Farm 2 entry vanishes from the list, only my model packs are left - When I run POD Farm 2 it complains again that I have to authorize in the License Manager, but there is nothing for me left to authorize - In the end POD Farm 2 only runs in trial mode It is basically the same problem as in http://line6.com/support/topic/22827-pod-farm-2-only-runs-in-trial-mode/ but in contrast to that thread I'm 100% sure I have a POD Farm 2 license, since I switched from the red-faced UX2 to the my current black-faced UX2 specifically for POD Farm 2. I submitted a support ticket as well, but I was hoping for some suggestion meanwhile. Cheers Oliver EDIT: Turns out I'm an idiot and confused my switch from Gearbox to POD Farm 1 with an imagined switch from POD Farm 1 to POD Farm 2. I never had a POD Farm 2 license. The License Manager still shows a POD Farm 2 license sometimes though, which contributed to my confusion. I leave this topic up so anyone is as dumb as me well have something to go on.