Search the Community
Showing results for tags 'dt50 212'.
Found 3 results
I have a DT50 212 and recently picked up the pod go. I'm attempting to use the 4 cable method (yes, I am sure I have the cables routed correctly). It seems like I am not getting any tone from the amp (none of the controls affect it, including drive, channel vol, and master volume) and the only way to change the volume is with the volume knob on the pod go. I was hoping to be able to use the amp tones in the amp and use the pedal for drive/boost and wet effects. I have even disabled all of the effect blocks and the amp/cab blocks in my Pod Go preset, and nothing changes. What am I missing?
I'm wondering if the master volume on my DT50 is behaving normally. I am using an EMG81 active pickup plugged into the LOW input. I have the amp on topology IV and have the channel volume all the way up. When I slowly increase the master volume, I have to bring it up a bit before I suddenly get a loud signal. Before that threshold there is no signal (relative silence with no guitar signal). I turn the channel volume down and noticed the curve of the master volume's behavior is somewhat the same. I take it past the same (or very close) threshold and suddenly there is a healthy dose of volume. Is that normal behavior for everybody else's amp?
I want to use the direct out of my dt50 212; My intention is the follow; guitar, amp input, direct out, mic soundcard input...master amp level about 50%-60% (i use a SPL reducer for lowering the out volume) and add effects in cubase ( IR cab, delay or reverbs etc) any help or suggestions? Thank you :)