Search the Community
Showing results for tags '412'.
Hi All, I have a 412VS that I use with my Vetta II head, but i recently purchased an Orange Jim Root Terror which sounds awesome through it. My only problem is, it only has one channel. So my question is: Is it possible to run my Vetta II through two of the speakers for clean tone and my Orange Jim Root Terror through the other two for the dirty tone? I know the cab is stereo so I'm assuming that means top two speakers are separate from the bottom two... If so, any ideas how? Thanks for your help!
Hey guys, So I've recently picked up the DT50, and one of the 4x12 cabs with the Celestion V30s in it (sounds friggin killer), but lately I've noticed a slight buzz when i'm playing heavier palm muted notes, especially on the decay of the note. I've taken the back off the cabinet and tightened all the screws on the speakers and everything looks fine, but I'm still getting some of that buzz. I think its coming from the center post (that's stapled to the front of the cab, and then the back panel screws into it). I was thinking of maybe putting some poster putty (the blue stuff) around the edges and working it in there, because I'm hesitant to just glue it all up. Do any of you guys have experience with this, or have you done anything else to your 4x12 to get rid of any unwanted sounds? I've done some research, and seen a few forum posts about similar things, but I figured I'd give a shout out to the L6 community. Thanks! -Jason
Hello fellow forum members, I just bought a Spider III HD150 head (on its own) and now am looking for a 212 cab to buy. A 412 is not an option now, it may be too big for my car to carry around (we're gigging a lot). So after reading many entries, my (very n00b) questions are: - can this head be run in mono mode? I mean I just did (on a gig), I hooked it to a H&K 212 and fortunately I didn't blow the amp. But may this happen at all? - do you know any not-too-expensive 2*12 cabs that may fit with this amp (technically speaking)? It's not easy to fin 212's with two 8 ohm inputs stereo. Thanks a lot!
Good day everyone !! I just have a couple questions about this method. I want to connect my 2x12 Spider III 150 amp to a 4x12 cab (Line 6, as well) but I'm not sure if I must disconnect the 2x12 speakers in the combo to use the 4x12 cab, or does the amp automatically cancel the 2x12 output when the two cables are plugged in to the cab ? I will thank every single comment Thanks and have a nice day.