Search the Community
Showing results for tags 're-amp'.
Found 2 results
-
So I'm working on a little project where I need to record the same signal through an effect with several different settings in hopes I can get it tone-matched. My DAW of choice is Sonar (Cakewalk) which I have been using since it was a DOS program !!! So I kinda know my way around it. I'm currently using a Focusrite Scarlett 8i6 interface. After about 30-45 minutes of epic fail and a few occasional loud squeals from attempting to use the loop-back ability of my DAW, I remembered the Helix manual mentioned re-amping... and the helix has the ability to add loops. About 15 minutes was all it took and most of that was copying the source file to the laptop I use with the Helix in the other room and plugging things in. The DAW (Sonar) was up and running and setup to record within the 1st 5 minutes. I just followed the instructions on page 53 of the manual. I created a pre-set, and the only blocks were a send and return (set to 100% mix). Done !!! What an amazing unit. -
Hi, I tried to re-amp using a real amp and my tone port UX8 with no success. All outputs from 3 to 8 (1 and 2 is for my monitors) produces extreme hum or "SHHHHHHHHHHHH" sound when plugging it into my Real guitar amp. I do not even have to send a signal through the output to produce this noise. As soon as the jack is connected the extreme "SHHHHH" starts. I have tried isolating the problem and found it must be the TonePort itself. I done the following tests: 1) To eliminate the cable I plugged my guitar into the cable that goes to the amp - NO NOISE. I immediately unplugged my guitar and plugged it into the TonePort - NOISE 2) I have switched off everything else e.g. Computer, Monitors. Only my tone TonePort was on. SAME NOISE. Does anyone have ANY other suggestions? I am at the point of getting rid of the TonePort. Another user experienced the exact same problem in this thread: http://line6.com/supportarchivenew/thread/91525/
