Please ensure Javascript is enabled for purposes of website accessibility Jump to content

Search the Community

Showing results for tags 'string noise'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Community Support
    • Multi-Effects Units
    • Variax Instruments
    • Amplifiers
    • Computer Based Recording
    • Live Sound
    • Pedals/Controllers
    • Dream Rig - Line 6 Product Integration
  • General Discussion
    • Tone Discussion
    • Line 6 Lounge


  • General FAQ
    • Operating System-specific Information
  • Tutorial Videos
  • Effects/Controllers
    • HELIX/HX
    • DL4 MkII Stompbox Modeler
    • FBV Controllers (MKII / 3)
    • M5
  • Amplifiers
    • Powercab
    • Catalyst
    • Spider V
  • POD
    • POD Go
    • Pocket POD
  • Guitars
    • JTV / Shuriken / Variax Standard / Workbench HD
  • Relay/XD-V Digital Wireless
  • Recording
    • Helix Native
    • Metallurgy
    • Echo Farm/Amp Farm
    • POD Farm 1/2.0/2.5
    • Computer Audio Set Up and Troubleshooting
  • Legacy Products
    • POD
    • Amps
    • 1st Gen Variax Guitars / Bass / Workbench
    • Effects and Controllers
    • AMPLIFi Series
    • Live Sound
    • Digital Wireless
    • Mobile Products
    • POD Studio / Tone Port / GuitarPort
    • Software
    • Dream Rig

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Registered Products

Found 2 results

  1. Since I loaded HD models onto my JTV59 I have noticed a 'quack-like' string noise when I strum the humbucker models (Lester, Special and 335) that was not evident on the 1.9 versions of these guitars. Has anyone else had this problem? How can I fix it? I strum with my fingers rather than with a pick. Thanks for your advise.
  2. Every now and then I seem to end up constructing a preset that really accentuates unwanted string noise to the point where is close to or as loud as the guitar signal. String noise as in when you can hear every little slide and bit of friction applied by your fingers to the strings as if there was a microphone right next to your hands. It tends to happen more often as you would expect on higher gain tones but also sometimes on clean sounds. Haven't really analyzed it well enough to know whether it is a particular amp model or setting, EQ issue, compressor or other effect setting or whatever. When I do stumble across these I start mucking about with my amp settings and EQ primarily, bypassing effect blocks, etc. and generally trying to locate the source of the string noise but I have not really discovered the magic bullet. Most recently I am encountering it on a preset based on the 'Archetype Lead' amp set up for higher gain crunch and lead snapshots. Anyone have any specific suggestions in general on what the most likely sources of string noise are and what to tweak to minimize it? I believe I have tried most of the more obvious cuts in the mids and highs but I seem to be missing something and could use some more specific suggestions. Could it be a pad or impedance setting? I usually use 'Auto' for the impedance unless I am using a fuzz block or something else that requires custom impedance settings. It happens on different guitars with different strings so it does not seem to be linked to one guitar, particular string set, or set of (microphonic)pickups.
  • Create New...