Jump to content
Sign in to follow this  
Ayiangoullis

Automatically changing Pod HD Pro X patches in reaper

Recommended Posts

So I use an m-audio midiport to change my pod's patches during live shows. However when a patch changes, there is a small interruption of sound (for about half a second) which sounds bad in the mix... Is there a way to make the change faster?

If not, I basicly change between rythm and lead patches, so can I change some parameters of the patch (like turning pedals on/off. or amp settings) using MIDI signals? I just want to make our live sound as perfect as it can get...

Share this post


Link to post
Share on other sites

There is going to be an audible interruption when changing patches. Not much you can do about that except timing it as best you can, or writing the music to accommodate for it.

  • Upvote 1

Share this post


Link to post
Share on other sites

There is going to be an audible interruption when changing patches. Not much you can do about that except timing it as best you can, or writing the music to accommodate for it.

Ok. But can I change other parameters, like I said above, with the midi interface?

Share this post


Link to post
Share on other sites

Ok. But can I change other parameters, like I said above, with the midi interface?

 

You can turn effects on and off within a preset by sending the CC# associated with the footswitch you have them assigned to in the preset. As far as controlling parameters directly, you can't do it. You can control some indirectly by assigning them those EXP1 or EXP2 and controlling those with MIDI.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×