crypticify Posted September 22, 2015 Share Posted September 22, 2015 My X3 is literally dying for reasons unknown !! There is no input even if I switch on the tuner. No Output at all. Nothing is working. I only get sound through my Aux input and only through phones output NOT through the LIVE L/R outputs.. This is awful. I reinstalled the firmware, calibrated all the switches and pedal...Nothing... Why is this happening line 6 ??? Quote Link to comment Share on other sites More sharing options...
psarkissian Posted September 22, 2015 Share Posted September 22, 2015 Go to "Inputs" and check the edit page, then dial in the selection. Typical and most common Outputs,... edit page,... "1/4 inch Output" "Match Studio/ Direct Mode" The afore mentioned are a typical generic set-up. More than likely something got switched in the edit page and wasn't switch back. Quote Link to comment Share on other sites More sharing options...
crypticify Posted October 1, 2015 Author Share Posted October 1, 2015 I checked everything, it is already i Match Studio/Direct Mode with 1/4 inch outputs. Still no sound Quote Link to comment Share on other sites More sharing options...
silverhead Posted October 1, 2015 Share Posted October 1, 2015 On the outputs page make sure that neither Tone is set to Mute. Also check the top right area of the X3 Live device. Make sure the Amp/Line switch is not in the middle position; this acts as a mute switch for the 1/4" outputs. Quote Link to comment Share on other sites More sharing options...
psarkissian Posted October 1, 2015 Share Posted October 1, 2015 Yes, that too,... Would've gotten downstream eventfully,... thanks for covering my back. :) You have the "guitar+aux" selected (or other inputs selected) at the input on the input edit page? Quote Link to comment Share on other sites More sharing options...
silverhead Posted October 1, 2015 Share Posted October 1, 2015 Not really trying to cover your back - you don't need that by any means! Just trying to respond to the OP more quickly (I'm in the Eastern time zone). Quote Link to comment Share on other sites More sharing options...
BillBee Posted October 1, 2015 Share Posted October 1, 2015 Hey Fellas, My spare X3L has the same issues but I correct me if I am wrong here "that after setting the unit to tone 1 and the inputs to guitar + aux" if the tuner does not detect an input signal its "service time". Jack failure or mainboard. If the tuner never sees the signal the output settings won't matter much. If any one can ballpark a rough estimate for worst case scenario (mainboard) shoot it over. -Bill Quote Link to comment Share on other sites More sharing options...
psarkissian Posted October 1, 2015 Share Posted October 1, 2015 Check for the latest firmware updates, Make sure the tuner is not in audio bypass. You wouldn't believe how many people forget that's there. Even I've done it a couple times. For two of you, I would think it's time for a general overall check up at a Line 6 authorized service center. Check for any hardware and firmware updates,... ... especially if it's been some time and they haven't seen a service center yet. And thanks silverhead,... always on the ball. Quote Link to comment Share on other sites More sharing options...
minhmeoquay Posted October 18, 2015 Share Posted October 18, 2015 they need new firmware now for Os X El Captain Quote Link to comment Share on other sites More sharing options...
psarkissian Posted October 19, 2015 Share Posted October 19, 2015 Go to "Inputs",... what comes up in the display? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.