gruser Posted August 26, 2013 Share Posted August 26, 2013 Hi,I am using the above setup to drive some East West VSTs. This works fine for the most part.I have one very annoying issue. When the first note is played there is a slight glitch noise/delay while the midi appears to "kick in". Every note after this is fine with no latency until there is a break in playing. Then the same situation repeats for the next "first note". The issue isnt limited to Cubase 7 and occured in Cubase 5 too.In what maybe a connected issue the metronome (using audio beeps) only sounds while I am playing guitar over direct monitoring. If I stop playing the metronome cuts out.Would appreciate any help here! Quote Link to comment Share on other sites More sharing options...
TheRealZap Posted August 26, 2013 Share Posted August 26, 2013 I've has a similar thing happen with logic... in the end i found my timing was slightly off... i went to the midi edit view and sure enough the initial note was just outside of the loop area... dragged it inside the loop area and everything was fine...anyway... just something to look at. it seems i anticipated the note just the tiniest fraction during count in. Quote Link to comment Share on other sites More sharing options...
gruser Posted August 26, 2013 Author Share Posted August 26, 2013 Thanks for the response Zap. This isnt just a recording problem. Even live playback, the first note "glitches" and plays slightly late. Subsequent notes are ok until there is a break in playing. Then the first note of the next section only glitches again, subsequent notes are again fine. Its driving me mad! Quote Link to comment Share on other sites More sharing options...
gruser Posted August 28, 2013 Author Share Posted August 28, 2013 Any midi analysis tool I could download to diagnose this? Quote Link to comment Share on other sites More sharing options...
gruser Posted August 31, 2013 Author Share Posted August 31, 2013 The feedback from the Steinberg forums is that there maybe some gate function on the toneport? Do line 6 have gate functions for balancing the input and DAW? Could I have something misconfigured? I see a gate button on the plugin but on or off produces the same behviour. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.