Please ensure Javascript is enabled for purposes of website accessibility Jump to content

Help??? How to undo push and turn in snapshots?


reggibeasley
 Share

Recommended Posts

Hi guys. I use push and turn in snaphsot mode to adjust specific settings to individual blocks- such as gaining the amp up in snapshot one, then gaining it down in snapshot 2. What I can't seem to figure out is how to remove the push and turn so that it goes back to being universal across all snapshots. Thanks for the help in advance. 

 

Link to comment
Share on other sites

Hold the bypass button and then immediately push the control encoder knob for the parameter you wish to de-assign - that's the quickest way - brackets will vanish immediately.

 

(I've accidentally twist-turned quite a few times....)

  • Upvote 4
Link to comment
Share on other sites

This will probably sound silly, I'm a complete noobie to the Helix, but why do you have to get the white text up in brackets per snapshot?

 

Think I've been just turning the nob without pushing it too, then saving per patch.

Link to comment
Share on other sites

Not sure I understand what you're saying, but without the brackets, that parameter isn't controlled by snapshots (or any other controller), so it has the same value in every snapshot.

OK thanks, I understand now.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...