Jump to content
Sign in to follow this  
jackdimebag

Pod HD Pro X power amp setup

Recommended Posts

I have a pod hd pro x and a Rocktron Velocity 300.

I was told I need to run my poweramp in bridged mono but when I do that I get lots of pops and buzzing noise. I'm not sure i'm doing something wrong or if the poweramp is broke? My pod global settings are all correct with the stacked power amp setting etc. Any help would be appriciated as its getting rather annoying.

 

*Works perfect when its in stereo and only one speaker cable going to my cab. 

 

Thanks

Share this post


Link to post
Share on other sites

Not sure the HD is the issue here. You might want to check out the manual for the Velocity regarding cab ohmage and stereo requirements. Stereo = two loads for the power amp, bridged = single load. Cab specs should match what is required.

 

From my old trusty Velocity 120 I know that when it would start to overheat the thermal protection would begin to make the sound start to distort.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...