Jump to content

Recommended Posts

My blackstar stock channel switching pedal is not working while using hx effects.  I cannot switch to channel two. It's as if channel two is bypassed. The pedal turns red as does the channel two light but channel two seems to be disabled. If I plug my guitar directly into my amp and disconnect the hx effects entirely channel  two works again, but once I reconnect the hx effects the stock pedal can only be used to turn on and off reverb and channel switching is disabled. I'm currently using the 4 cable method. 

Share this post


Link to post
Share on other sites

It sounds like you're probably bypassing your amp's preamp. In order for the 4 cable method to work with the HX Effects, you have to inserts an FX Loop block in its signal chain. It's different than the M13, in case that's what you were coming from.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×