mbtainton Posted July 2, 2018 Share Posted July 2, 2018 Anyone running a patch with separate effects chains out to the L and R outputs without them being mixed together at the end of the chain? i want to run out to two amps and have a EQ block only apply to one amp. Quote Link to comment Share on other sites More sharing options...
tjbassoon Posted July 2, 2018 Share Posted July 2, 2018 Easy. Create your EQ block, use the action button to move it "down" and create a new signal path. Find the point where it joins the original signal path again and use the action button to move that down so that it's a separate output. Configure your outputs so that one goes out the Left 1/4" and the other goes out the Right 1/4". Quote Link to comment Share on other sites More sharing options...
mbtainton Posted July 3, 2018 Author Share Posted July 3, 2018 On the HX I can create the parallel signal path and I can find the merge point where the mixer is. I can drag the mixer down to the parallel path and then path A shows an output of Main L/R and path B shows an output of Send 1/2. I can see where these can be changed. Does this mean that to run separate chains into separate amps I have to run one amp lead out of output A and the other out of the send jack for one of the loops? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.