Amplifi 150 +-45 volt power supply not present

[BjoernGeller]

Hi there, the power supply doesnt have either + nor - 45 volt power supply present. The other voltages are OK.

First question, for a working unit should there be +-45volt present at the output of the power supply or is there a possibility that it is switched off due to some settings on the amp?

Does anybody have experience in fixing the power board and can recommend where to look as I dont have a schematic.

 

I suspect that the fault is in one 8 pin chip: 5181 PQAC it gets the output signals from the SG3525AP but I could not find the 5181 anywhere.

Does anybody know what that chip actually consist of ???

bg@bgcontrol.com

[manolonte]

Hi,

 

did you manage to fix your AMPLIFi? Mine has a blown transistor, close to that 5181 IC. So blown that I cannot identify it. Can anybody tell me what transistor is in that position? It is the only non SMD transistor, at the other side of the two big capacitors, where I have put the socket you can see in the second picture.

 

Thanks in advance,

Manuel 

[Frazierf1]

Thanks for sharing, I found a lot of interesting information here. A really good post, very thankful and helpful that you will write many more posts like this one.

[Joe756]

I am trying to do this also and getting the same response. My Ascension Employee Portal

[Joe756]

I have the same problem and really know ***** I do not know what to do I can not find a solution help me  Marriott Global Source