puneetxtaneja Posted April 15, 2019 Share Posted April 15, 2019 Does anyone know what kind of cab/mic/mic placement simulation is included in the DT25 Direct Out? Is there any way to turn off the cab simulation and use and external cab loader? Quote Link to comment Share on other sites More sharing options...
phil_m Posted April 15, 2019 Share Posted April 15, 2019 If you have the 2.0 firmware loaded on the DT25, you can select "None" as the cab by sending the MIDI CC message associated with that. https://line6.com/data/6/0a06434df0f650914b2056015/application/pdf/DT Amplifier MIDI Implementation Guide - English ( Rev A ).pdf The other thing you could do is use Low Volume Mode and use take the output from the DT25's effects send into your cab loader. In Low Volume Mode, there power amp modeling applied to the preamp section. If you do this, though, you're not getting any actual contribution from the DT-25's power section. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.