telengard Posted September 20, 2019 Share Posted September 20, 2019 I seem to have upgraded to 2.8.0 on my rack successfully, but every time I turn it on, I see it takes a bit of time as it "rebuilds patches". Is there more I need to do after upgrading the firmware? thanks Quote Link to comment Share on other sites More sharing options...
Peter Posted September 20, 2019 Share Posted September 20, 2019 It should only do this once (if you do not edit your patches again). I would do a reset(9+10) and load the backup. Then wait and let the Helix completely rebuild your patches. Hope it works the next time without rebuilding. Quote Link to comment Share on other sites More sharing options...
telengard Posted September 20, 2019 Author Share Posted September 20, 2019 Thanks Peter, I will try that tonight. Quote Link to comment Share on other sites More sharing options...
telengard Posted September 20, 2019 Author Share Posted September 20, 2019 What are the reset switches on the rack version of the Helix? I don't have any numbered switches like the floor version. Quote Link to comment Share on other sites More sharing options...
Peter Posted September 20, 2019 Share Posted September 20, 2019 7 minutes ago, telengard said: What are the reset switches on the rack version of the Helix? I don't have any numbered switches like the floor version. https://line6.com/support/page/kb/effects-controllers/helix/helixrackltfxstomp-reset-procedures-and-troubleshooting-tricks-r768/ Quote Link to comment Share on other sites More sharing options...
Peter Posted September 20, 2019 Share Posted September 20, 2019 ...if it does not help maybe you can find a solution here Quote Link to comment Share on other sites More sharing options...
FukinA15 Posted September 22, 2019 Share Posted September 22, 2019 I'm having the same problems it rebuilds on every bootup. Quote Link to comment Share on other sites More sharing options...
telengard Posted September 23, 2019 Author Share Posted September 23, 2019 I updated to 2.8.1 last night and it still happens on every boot up. I've never saved a backup, so would "reverting" to one actually work? I have 3 of my own pre-sets and 2 of them are used for send/returns. Quote Link to comment Share on other sites More sharing options...
Peter Posted September 23, 2019 Share Posted September 23, 2019 You never saved a backup befor an update, ...very risky. Maybe your problem is similar to this: If you have only 3 own user presets and no IRS, I would save/export only these presets and do a factory reset( ENC5 & ENC6 ). This updates the factory presets / overrites everything. Try, if it works now without rebuilding on every boot up. If yes, you can import your saved presets. If it happens then on every boot up again, one of your own user presets is probably faulty. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.