Jump to content
thetragichippy

POD GO - VOLUME PEDAL

Recommended Posts

Anyone use volume pedal on GO POD and notice it works, volume gets softer until all the way back and It goes back to normal. Any fix to this, I would like to silent my guitar by using volume pedal

Share this post


Link to post
Share on other sites

Are you talking about the on-board expression pedal or an external pedal?

Share this post


Link to post
Share on other sites
35 minutes ago, phil_m said:

Are you talking about the on-board expression pedal or an external pedal?

The internal (one that come with the POD GO. When I back all the way off, it come back on to normal volume. 

image.thumb.png.ccf945094f41ddd34cc3139f3aa3e952.png

Share this post


Link to post
Share on other sites

I have noticed that the last few Factory Presets (the ones with the spacey reverb and delay sounds - I don't have my POD Go on right now, so I don't remember the names of the presets) have an issue with the volume pedal, where it does not seem to affect the presets at all.  Anyone else noticed that?  I'm guessing it might be due to the DSP not having enough RAM to include the Volume pedal in the preset? I could be wrong.

Share this post


Link to post
Share on other sites
2 hours ago, Dimaension_X said:

I have noticed that the last few Factory Presets (the ones with the spacey reverb and delay sounds - I don't have my POD Go on right now, so I don't remember the names of the presets) have an issue with the volume pedal, where it does not seem to affect the presets at all.  Anyone else noticed that?  I'm guessing it might be due to the DSP not having enough RAM to include the Volume pedal in the preset? I could be wrong.

I've checked on my POD Go and I don't see this behaviour. The VOL pedal works on the later factory presets unless you manually turn it off. I do notice that these presets are very heavily effected, as you say. This causes the change in VOL pedal position to be less noticeable and somewhat delayed, but it's working for me. Press the pedal to full heel position and wait a few seconds; the sound disappears.

 

A VOL pedal consumes very little DSP - that's not an issue.

Share this post


Link to post
Share on other sites

I don't find that I'm getting a smooth volume sweep through the motion of the pedal.  I feel like I'm getting full volume, full volume, pretty much full volume, and nothing as I go from top to bottom.  Any settings to try?

Share this post


Link to post
Share on other sites

@miami_vice try moving the volume pedal later in the chain. Especially after drives or after the amp. Put it on logarithmic sweep instead of linear.

Share this post


Link to post
Share on other sites

Good morning-  I recently got a Pod Go- I love it.

However, when the wah is switched ON, all the lights blink and the sound cuts out for a second about 1/3 through a pedal rock.

Also, Is there a way to switch the wah off when in volume pedal mode? 

Please assist
Thanks so much

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...