JMolson Posted June 23, 2020 Share Posted June 23, 2020 I really can't believe this . Edited::: After almost two days I've been able to restore my DAW PC.. I'm done fighting Pod Go and the editor. I'm tired of getting disconnected every 2 seconds Quote Link to comment Share on other sites More sharing options...
JMolson Posted June 24, 2020 Author Share Posted June 24, 2020 I need to preface this by saying I've been a Line 6 user since the original bean... I've owned more Line6 gear than I can remember.. I still use the UX2, Variax 700,, JTV 89F, Helix rack and others in storage I'm sure I've forgotten.. This is the most frustrating pc of hardware I've tried to integrate into my studio in a long long time.. Not ready for prime time.. I had enough problems with my Helix Rack unit to where I had to send it in to be serviced.. This however is a completely different level of effed up.. BTW Line 6,, your support center is not open until 4pm PST.. You close at 3:00 after an hour of lunch from 12-1:00pm Might want to change that on your support link... That matters to east coasters ;) Quote Link to comment Share on other sites More sharing options...
JMolson Posted June 25, 2020 Author Share Posted June 25, 2020 Enough's enough. This trainwreck of an experiment is over and this unit is going back. Nothing works on this unit. Buttons knobs, editor, nothing. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.