ixagr8 0 Posted February 10, 2014 I have an older 2.0 Pod that just stopped working. I have no output and the tuner doesn't even register. Suggestions? Quote Share this post Link to post Share on other sites
cruisinon2 2,547 Posted February 10, 2014 I have an older 2.0 Pod that just stopped working. I have no output and the tuner doesn't even register. Suggestions? If the tuner isn't registering, the unit may not be receiving any signal at all. Could be either dead cable or dead 1/4" jack on the guitar (usually just a loose solder connection). Try another cable first, if it still doesn't work, then try another guitar. Sometimes it's the simple things... Quote Share this post Link to post Share on other sites
ixagr8 0 Posted February 11, 2014 Cord=Good Guitar=Good I'm beyond the simple things. There is no input or output signal. Channels function ok. Did a factory reset; pod boots up to "1 A" everytime. Lights are on but nobody's home. No buzzes like cold solder joints or bad ground. I'm thinking it's a factory RMA that's gonna get 'er working again. I appreciate your comments and if you think of anything else, please holler! Thanks! Quote Share this post Link to post Share on other sites
Mr_Arkadin 1,572 Posted February 11, 2014 Are you using the original PSU? Quote Share this post Link to post Share on other sites
jaygoast 0 Posted March 9, 2014 I had the same problem. Make sure your using the correct power supply. Quote Share this post Link to post Share on other sites
