Cre8tivexpert Posted October 10, 2020 Share Posted October 10, 2020 Help - My POD 2.0 has started to exhibit some kind of input clipping/interference. I’ve checked cables and surge protector and everything is normal there but intermittently the input sound will glitch. Dos this indicate that my device is dying? I’ve heard of capacitors going bad but has anyone experienced this and how did you resolve. Much appreciated. Might be time to pull the trigger on a POD Go. Quote Link to comment Share on other sites More sharing options...
daveny5 Posted October 10, 2020 Share Posted October 10, 2020 You may want to try a few things: Swap your cables and see if that helps. (I recommend not using homemade cables.) Check your settings, especially the AIR switch. Try moving all of the knobs and sliders. Work them a little bit. Over time they can get oxidized and that can cause problems. Good luck. Quote Link to comment Share on other sites More sharing options...
Cre8tivexpert Posted October 10, 2020 Author Share Posted October 10, 2020 Thank you! I will try your suggestions! Gabriel Quote Link to comment Share on other sites More sharing options...
Cre8tivexpert Posted October 11, 2020 Author Share Posted October 11, 2020 Thank you daveny5! My POD 2.0 is working properly now after your suggestions! I gave all the knobs and sliders a little back and forth and slid the Air switch back and forth a few times and now the clipping is gone. Thank You Again! Quote Link to comment Share on other sites More sharing options...
daveny5 Posted October 12, 2020 Share Posted October 12, 2020 You're welcome. Glad I could help. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.