adkenyon Posted November 16, 2020 Share Posted November 16, 2020 I have a modeler, and really like the look of the 212 plus for running stereo through digital I/O (no Line6 link for me unfortunately, meaning an additional MIDI cable). But I also would like to use it for a full range signal (either a console mix, or from a microphone pre for when I sing backing vocals). Anyone know if you run digital stereo out to the 212+, if you can still run a (mono) analog input to the Aux input in monitor mode? Or does this mean the digital signal will be summed to mono, because you can only have 2 channels total??? Quote Link to comment Share on other sites More sharing options...
HotRats73 Posted December 1, 2020 Share Posted December 1, 2020 You can feed your 212 with a mono signal without affecting everything else. meaning you can use it as a stereo speaker for your guitar and at the same time as a FRFR monitor for your vocals (or whatever). form the manual: On Powercab, navigate to Global Settings by holding the HOME button and set Input 2 Mode to Monitor. This will use a separate crossover and filters to provide flat-response, full-range audio through the Powercab built-in amplifier and speaker(s) – just like an active PA monito Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.