pol2711 2 Posted December 1, 2020 Hi guys, My new POD GO came in today. Unpacked the box and plugged it in. Nothing happens except what you see on the picture. Tried C+D pushed in for more than 20 seconds and power on The same with buttons A+B Installed POD GO Edit and page -> pushing while firing up. Nothing. POD GO edit says nothing is connected. Now I'm outa options. Hopefully someone can help me? Sending it back is not what I'm happy with..... Quote Share this post Link to post Share on other sites
pol2711 2 Posted December 2, 2020 thx. Tried the special updater and after 2 attempts it's running again Quote Share this post Link to post Share on other sites
grdGo33 19 Posted December 2, 2020 Good times... Pretty amazing you got a unit which was dead on arrival. Where did you purchase it from? I'm guessing someone bought the Go, tried to update its firmware, it bricked the unit, then the customer returned it, and the shop just sold it to you as if it was a brand new unit. It's either that, or Line6 has ZERO QA and they're shipping 'dead' units lol which I doubt... Quote Share this post Link to post Share on other sites