Jump to content
Sign in to follow this  
logicbdj

Tone Port UX8 and meter problem

Recommended Posts

This problem is not causing any noise issues, but it's annoying, since everything was fine until now. With the interface not even connected and with nothing plugged in (I only had the USB and line out to a mixer with the same issue) my meter levels show maximum output. With things plugged in, they are merely maximized... but with things unplugged, the meters are maximized AND the 'clip' lights are flashing back and forth.

Share this post


Link to post
Share on other sites

Old thread I know, but here's my guess. You might have a mic pre with the gain knob set to max, routed to the main outs, which could cause the meter to think there is signal. Just a guess. I would go to the Line 6 Audio MIDI Devices control panel, and click "restore default" on both inputs and outputs tabs, turn down all knobs on the front of the UX8, then see what happens.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...