Helix LT: two different amp blocks two different imported ir blocks !

[Guido_59]

I would create a preset with two different amp block with two different ir blocks imported. The two amp blocks should be Small tweed and baseman for example , and it impulses imported for Red Wirez. 

I have tried to do using 1024 ir I creat a parallel chain with a second amp block but I cannot choose a second different it block. I can use the same ir.

Is there a way to do what I want?

Excuse me for my language 

 

Bye

Edited December 21, 2020 by Guido_59

[silverhead]

Depending on the other blocks in your preset you may be encountering the DSP limitation. To test, copy the preset to a different location and delete one or more of the other FX blocks in the same path. Can you now add your second 1024 IR?

[Guido_59]

Good suggest .

Tomorrow I wilI try it.

 

[codamedia]

The LT can certainly run the two amps you mention along with 2 x 1024 IR blocks in parallel on one of the paths... but there isn't a lot of DSP left over.

I suggest you build your preset by creating those amps/IR's,  then add effects. 

[Guido_59]

Thanks.

I try in a Little bit.

 

[Guido_59]

Hello guys. Problem solved.

Cause mistake I have loaded impulse at. 96khz from Red Wirez, so DSP  conversion capability to 48khz was probably too low. So I have loaded an original 48khz impulse as 1024 and by this way I was able to load 2 impulse at 2048 or 4 at 1024.

Thanks all of you.