jreidtba Posted April 11, 2021 Share Posted April 11, 2021 Just got a pod go recently and noticed that when I turn the unit off and then sometime later turn on it go use it my customers presets are gone. I have noticed that upon power up it says demo mode active, will reset all. I have searched everywhere and can not find anything on how to turn this demo mode off. Anyone else run into this issue? Quote Link to comment Share on other sites More sharing options...
spaceatl Posted April 12, 2021 Share Posted April 12, 2021 I have never seen that...try factory reset...Hold C & D on power up. Quote Link to comment Share on other sites More sharing options...
bax4bombs Posted April 12, 2021 Share Posted April 12, 2021 Having same issue and can not find solution as of now. Quote Link to comment Share on other sites More sharing options...
voxman55 Posted April 12, 2021 Share Posted April 12, 2021 New one on me too. If reset doesn't resolve suggest you raise a support ticket with Line 6. Quote Link to comment Share on other sites More sharing options...
MichaelRod74 Posted April 17, 2021 Share Posted April 17, 2021 Hey guys I just finally found out how to fix this As soon as you power on the POD Go , immediately hold down all 6 of these buttons ( BANK UP , BANK DOWN , A, B , C , and D . ) hold down all 6 buttons until it says Demo Mode deactivated. 1 Quote Link to comment Share on other sites More sharing options...
voxman55 Posted April 17, 2021 Share Posted April 17, 2021 1 hour ago, MichaelRod74 said: Hey guys I just finally found out how to fix this As soon as you power on the POD Go , immediately hold down all 6 of these buttons ( BANK UP , BANK DOWN , A, B , C , and D . ) hold down all 6 buttons until it says Demo Mode deactivated. Cool - I never even knew it had a demo mode until I saw this thread. How did you find out about this? Quote Link to comment Share on other sites More sharing options...
AbimaelAngeles Posted February 26 Share Posted February 26 On 4/17/2021 at 5:35 PM, MichaelRod74 said: Hey guys I just finally found out how to fix this As soon as you power on the POD Go , immediately hold down all 6 of these buttons ( BANK UP , BANK DOWN , A, B , C , and D . ) hold down all 6 buttons until it says Demo Mode deactivated. Thaks, I was able to solve the same problem with this Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.