CNight Posted June 17, 2021 Share Posted June 17, 2021 So I am attempting to edit a snapshot by adding an additional amp to it but all of the amps are inactive when I go into the edit mode. I can’t figure out why? Quote Link to comment Share on other sites More sharing options...
rd2rk Posted June 17, 2021 Share Posted June 17, 2021 You're out of DSP. Remove stuff until you recover enough DSP. Quote Link to comment Share on other sites More sharing options...
MusicLaw Posted June 17, 2021 Share Posted June 17, 2021 If you are using a Helix Floor, Rack or LT, move some of your Blocks to the 2nd Signal Path. On these units Paths 2A and 2B have their own DSP. Quote Link to comment Share on other sites More sharing options...
HonestOpinion Posted June 17, 2021 Share Posted June 17, 2021 "When you go down to 'Deep Edit' put your money in your shoes". Sorry, rd2rk and MusicLaw already answered the question so I couldn't resist the lyrical reference. Quote Link to comment Share on other sites More sharing options...
CNight Posted June 17, 2021 Author Share Posted June 17, 2021 Thank you for the feedback. Guess I'll do some research on creating a "2nd signal path." Quote Link to comment Share on other sites More sharing options...
soblivion Posted June 17, 2021 Share Posted June 17, 2021 What device are you using? If it's the Stomp you won't have a 2nd signal path(I think, I don't own it so correct me if I'm wrong). If it's any of the bigger units, Floor, Rack or LT you simply route the end of the path to 2A which effectively doubles your processing power. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.