sarang7158 Posted July 29, 2021 Share Posted July 29, 2021 I bought mission engineering sp-1 expression for my hx stomp. Like hx stomp manual I plan to use trs-tip, ring setting so bought rockboard slitter Y cable (trs - ts, ts) and tested it. then display shows and pedal work 0 - 100 - 0 curve. I heard trs can support the function of ts, then can't it overcome by setting it up? so I tested with my aux cable like trs-trs. but it work well 0 to 100 nicely (then i can't use fs5) I wathed youtube and searched another forum tried. but nothing was helpful to me I think sp-1 is little bit functionally different from sp-1 l6. Is that why I think sp-1 by sp-1 l6's standards? plz help me Quote Link to comment Share on other sites More sharing options...
datacommando Posted July 29, 2021 Share Posted July 29, 2021 59 minutes ago, sarang7158 said: I think sp-1 is little bit functionally different from sp-1 l6. Is that why I think sp-1 by sp-1 l6's standards? plz help me Hi, Not all Mission pedals are the same. Quote from the Mission Website page: "Revision B SP1-L6H pedals began shipping in December 2018. Rev B adds an enhancement to the pedal when used with the Line 6 HX Stomp. To connect a Rev B SP1-L6 to the HX Stomp, you may optionally use a single TRS cable in place of the TRS Y cable. This simplifies setup, and reduces wiring complexity on a pedal board." I suggest that you check this link for the information you require - there is also a video available there. https://missionengineering.com/support/line-6-electronic-user-guide/ Hope this helps/makes sense. Quote Link to comment Share on other sites More sharing options...
Schmalle Posted July 29, 2021 Share Posted July 29, 2021 10 hours ago, sarang7158 said: ... so I tested with my aux cable like trs-trs. but it work well 0 to 100 nicely (then i can't use fs5) ... You can use FS5 like that! HX -> TRS -> cable splits into TRS -> ME expression and TS -> FS. Connections: HX T -> ME T HX R -> FS T HX S -> both ME and FS S ME T not connected T = tip, R = rIng, S = sleve, HX = HX Stomp, ME = Mission Engineering expression pedal, FS = footswitch You can also use a TRS to 2x TS split cable and isolate the first 5mm of the sleeve of one TS plug with some thin tape for the ME. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.