thomhu Posted December 14, 2021 Share Posted December 14, 2021 I would like to assign the "drive" knob of the amp simulator to a switch. Kind of like on a analogue setup where you would switch to channel 2 for a little more dirt. Since I am not using the effects loop, in one of the factory presets I want to use that switch. I go to the drive knob on the amp , push the button down, tell it to learn, and then press the switch. It asks for a range and I enter a number in the low and high boxes slightly higher than my clean sound. Then I tell it to replace instead of merge. However, when press the switch, I get no sound. What am I doing wrong? Is only a pedal assignable to amp drive and not a switch? Thanks, Thomas Quote Link to comment Share on other sites More sharing options...
phil_m Posted December 14, 2021 Share Posted December 14, 2021 Which product are you talking about? Quote Link to comment Share on other sites More sharing options...
thomhu Posted December 14, 2021 Author Share Posted December 14, 2021 woops Forgot to list the product - it's the pod go wireless with firmware 1.3 -Thomas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.