Jump to content
Sign in to follow this  
dethpoi

Replacement Jack For Variax 300

Recommended Posts

Hi Folks,

 

I know that this was discussed before but I can't seem to find a conclusion of how to replace the variax connector on the 300. I have one that works intermittently. Push the  cat 5 cable toward the narrow end and it works, toward the wide end and it doesn't. I am assuming that it is finally wearing out.  Can someone suggest the easiest way to replace  or maybe adjust this for  novice? I don't want to send it to a service center since I am in Hawaii. I was hoping for a simple DIY solution. 

Share this post


Link to post
Share on other sites

See if any of the pins look  bent or damaged.  You may be able to straighten a bent pin.  Common cause of damage on these is accidentally trying to plug the 1/4 inch plug into that jack.  It happened a lot on the old Variax's.  Everyone loses the rubber  plug that comes with it to cover the jack.  The JTV has a hinged cover - much safer.

Share this post


Link to post
Share on other sites

When you say the pins do you mean inside the guitar or just looking down the barrel of the jack from the outside. 

Share this post


Link to post
Share on other sites

If you are unable to fix the jack, a replacement part is available. The plastic piece that houses the 1/4" jack and the VDI jack can be removed and replaced. It's simple - a few screws outside and a plug-type connector inside. You will also need to remove the pickguard (another few screws) to access the plug connector inside.

 

Call Line 6 (see Contact Us at the foot of this page) and ask them to refer you to your nearest Line 6 parts supplier. They should be able to mail it to you.

Share this post


Link to post
Share on other sites

Note also if you replace the entire jackplate assembly, the new ones (I guess designed for the JTVs) are slightly longer and you'll need to attack the body of your 300 with a chisel and hammer in order to remove some timber allowing it to fit properly.

Share this post


Link to post
Share on other sites

I see that one fits the Variax Bass and the 300, 600 and 700.  Does anything fit the 500?  My input jack is getting worn out (side to side play between the cable and the jack).

Share this post


Link to post
Share on other sites

I see that one fits the Variax Bass and the 300, 600 and 700.  Does anything fit the 500?  My input jack is getting worn out (side to side play between the cable and the jack).

Most likely the same as for 300 etc.

 

Contact distributor - I reckon the unit they produce to replace faulty units on the JTV's will be used on older vaxes now, as the two I received appear to be the same as on the new JTV.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×