JSilver Posted April 6, 2014 Share Posted April 6, 2014 My DT25 was sounding like it was at half volume (I am not using half volume mode), then last night the volume went completely, halfway through a gig! There was still some slight sound coming from the amp..... But I could whisper over it, it was that quiet! I am using my Pod HD500 connected via Line6 link. I had to put the HD500 directly through the PA and everyone said (out front) what a great sound I had!! :) So, unless I can find out what is wrong with the amp, I shall be going direct to PA from now on! Anybody know what might be the cause of this problem?...... I am suspecting valves, as I can still hear a slight sound from it. If it were fuses or any other component, then I am sure it would be just dead with no sound at all? Quote Link to comment Share on other sites More sharing options...
robyone Posted April 6, 2014 Share Posted April 6, 2014 ...check the valves, because if it were fuses sound will stop at all ( you re correct ). Probably one power tube is broken... Quote Link to comment Share on other sites More sharing options...
JSilver Posted April 6, 2014 Author Share Posted April 6, 2014 Thanks robyone. :) That is what I was going to try. :) Quote Link to comment Share on other sites More sharing options...
Brazzy Posted April 6, 2014 Share Posted April 6, 2014 I just had a similar thing happen with my DT50, here's the thread. Could be the tubes for sure. You may want to try to turn it off for a bit and retry. Or maybe even try the factory reset by powering up while holding the topo and pent/tri switch. Amps in general can be of the flaky variety, lol. 1 Quote Link to comment Share on other sites More sharing options...
JSilver Posted April 6, 2014 Author Share Posted April 6, 2014 That's the problem with valves!..... They can be as you say "flakey"! That's why I have now decided to get a Line 6 L2m and use it for a direct monitor! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.