Setting Dt 25

[mgr10]

Hi

 

Sorry for my english

 

Prague - Czech republic :)

I want to share the experience with sound settings, specifically Podem HD 500 and DT 25th
After a few hours of laboring

 

 

 

1.SETTING sound DT25 without Pod HD 500 - DTEDIT

fimware version 2.0


I figured out that the sound is set in Dt25/50 are complete simulation preamp and poweramp and cabinet ! !.
Line6 calculated about the fact that they will use  Line6 speaker cabinet compatible with Dt 25 /50.
Sound comes out of the cabinet as a whole . eg JCM 800 - GT75 .

If you use a different head with a box , so you must turn off the DT -Edit cab simulation ! !


2. POD HD 500 -DT 25/50 and Line6 speaker cabinet .
Use eg HD -edit or set directly on Pod HD

Pod HD connected with DT 25/50 - L6 LINK
Below I have set the output to Stack power amp.
In HD edit a selection of amplifiers complete preamp poweramp and cab.
You can also just preamp with a cab or without.

 

3.POD HD -DT 25/50 and other speaker cabinets

 

 

Pod HD connected with DT 25/50 - L6 LINK
set the output to Stack power amp.
Selected only preamp and a cab. Simul off !!


More knowledge.
If you are using REVERB in Pod HD  , you need to off - reverb DT 25/50  to zero.Sorry for

my English

[Brazzy]

Nice info. Just want to give you a heads up. You should update your Pod HD500 with the new firmware that was just released. Thread Link