Jump to content
velok

L3m Has A Rattle Just Like The L2m

Recommended Posts

I just checked with German net shop Thomann, and was told that all their L2 speakers in stock was from the new production line with the new fan. I ordered from them. I haven't received it yet, so I cannot actually verify that it's correct, though...

Share this post


Link to post
Share on other sites

The rattle often comes from the speaker being pushed to the point where the speaker over excurses or moves beyond it's normal range - and causes damage. It will still work but no longer has the original "damping" and cone control. It's difficult to diagnose a speaker that seems to be working normally and the damage usually occurs over time. Use a sine wave tone generator (you can download all kinds of these for free to use on your smartphone)    plugged into an input channel on your mixer that's connected to your PA - start at a fairly low level and SLOWLY and gradually"sweep" the frequency from 40 Hz to about 180Hz in 10 cycle increments at a time  and listen carefully for any rattles, scraping sounds, distortion, or irregularities coming from your subs at each frequency. Problems will usually be emphasized or more apparent using this test method vs trying to diagnose issues during soundcheck or performance. It may need to have one (or more) speakers replaced with new units OR getting your tired speakers reconed by an experienced technician that is factory trained and authorized to do it. (Way less expensive)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×