boloulu Posted April 19, 2014 Share Posted April 19, 2014 Can you still hear the DT 50/25 if the XLR line out is sent to the PA? On the Spider IV the line out cancels the speaker in the amp so a floor monitor is needed to hear oneself. Line out is a great feature to prevent mic bleed from other amplified inst and vocals. Quote Link to comment Share on other sites More sharing options...
Brazzy Posted April 19, 2014 Share Posted April 19, 2014 I'm pretty sure you can do that. I ran the XLR out from my DT50 Head into a PA once but I had it in Standby and didn't try monitoring with the Speaker. I would try it for ya but my AMP is down at the moment. Quote Link to comment Share on other sites More sharing options...
aeugle Posted April 19, 2014 Share Posted April 19, 2014 Yes thats working. In standby mode there is no Signal. Quote Link to comment Share on other sites More sharing options...
sonic Posted May 6, 2014 Share Posted May 6, 2014 Yes thats working. In standby mode there is no Signal. unless you put it in Low Volume Mode... Quote Link to comment Share on other sites More sharing options...
aeugle Posted May 7, 2014 Share Posted May 7, 2014 Why is this ? Why only in low volume mode? Quote Link to comment Share on other sites More sharing options...
phil_m Posted May 7, 2014 Share Posted May 7, 2014 Why is this ? Why only in low volume mode? There have been some long threads regarding this here, but the way I see it is this. In full power mode, the signal going to the XLR out is being tapped from the output transformer so that the tube power amp affects the signal. In standby, the power tubes aren't operating, so this is why there's no signal. In low volume mode, the signal going to the XLR out is simply the signal from the preamp section with cab and mic modeling applied. The power amp interaction is modeled rather than real. It still works in standby in LVM because the signal isn't dependent on the actual power tubes in any way. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.