kutjaaa Posted June 4, 2014 Share Posted June 4, 2014 Hi All, A have a Spider Valve MK I with Shortboard MKI! A have a problem with my shortboard, when I connected to the amp, it always going to the edit mode! I tested what happen, and I found an interesting thing. When I knocking on the controller's chassis with My finger it is go to the edit mode or blinking the led of the FX loop, if I touch the FX loop switch (no I not push, just touch ) when I do this same thing happen! Because this problem appeared before our concert I disconnected the cable from the pcb of the FX loop and UP switch as short term solution! But it is not comfortable! Do anyone have idea what is the problem, the solder looks like good and the switch works fine! Regards, kutjaaa Quote Link to comment Share on other sites More sharing options...
cgtrox Posted June 18, 2014 Share Posted June 18, 2014 First thing to try is a new cable, after that I would definitely blowout the holes for the cable where it goes into the amp and the board to make sure there's no debris which is what hinders its performance.Just make sure it's firing on all cylinders! cgtrox Quote Link to comment Share on other sites More sharing options...
kutjaaa Posted June 23, 2014 Author Share Posted June 23, 2014 Thanks for Your answer, I found how the rj45 hole in the amp side was unstable when the amp is heated! I replaced this part and the problem is disappeared. Regards, Kutjaaa Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.