dattrax Posted September 4, 2014 Share Posted September 4, 2014 Hi, Just wanted to post this in case anyone else stumbles across the issue. I had an issue with really bad digital clipping in low volume mode. I removed the HD500 from the chain and went straight into the top of the amp, still no luck. The normal volume mode seemed OK, but low not. Anyhow, I read in this forum that the low volume mode is modeled and not done via the same signal path so I thought to upgrade the firmware. I was already on 2.0 (latest), but I went for the reflash anyway. When the amp came back up again, everything was back to normal, so either the program in the flash or some settings had been corrupted. Cheers, Jim 2 Quote Link to comment Share on other sites More sharing options...
Lution777 Posted September 5, 2014 Share Posted September 5, 2014 Interesting. I noticed this today too. Digital clipping in the overdriven amps in low power mode. I just upgraded to 2.0 today. Perhaps I'll perform a reflash as well. Do you know if your saved amps were still saved after reflashing? Quote Link to comment Share on other sites More sharing options...
Brazzy Posted September 6, 2014 Share Posted September 6, 2014 Sometimes you just have to re-flash to fix it. I've been there not for the exact problem though. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.