These forums are read only, please use our new forums here.

Main :: POD HD

Support forums for all POD HD products

Line6 Link with 2 HD Pros
by Shub-Niggurath on 2012-11-19 18:13:36.3510


Bit of an odd question - I searched but found nothing. Can I connect two HD Pro's together in a daisy chain and have the sound from both come out of the final one in the chain?

So it would go [HD PRO] ---l6 link---> [HD PRO] ==stereo out==> [AMP]

Ideally, I want the stereo sound from two independent HD pro's to come out of one amp and I don't have a mixer. I'm trying to sort out a live setup for two guitarists and don't want to add any more equipment

Has anyone done anything like this?



Re: Line6 Link with 2 HD Pros
by phil_m on 2012-11-19 19:27:53.5700

L6 Link doesn't offer any communication - data or audio - from one POD to another.

I'm confused as to what exactly you mean by having the audio from both PODs going into one amp. Is it a stereo amp? What exactly are you trying to accomplish?

Re: Line6 Link with 2 HD Pros
by Shub-Niggurath on 2012-11-19 19:40:43.9030

That's fine, it just wasn't 100% clear from the">"> page. I was hoping I could send audio over L6 Link from one HD to another and then use the combined signal for an amp input - so the L6 link audio would be merged in with the audio from the last unit in the chain. I didn't want to send any control parameters or anything like that, just audio.

I guess you achieve the same with the fx loop

Thanks for your reply


Re: Line6 Link with 2 HD Pros
by Rewolf48 on 2012-11-20 05:06:50.2150

Use the digital audio connections - unlike the HD500 which only has out the HDPRO can accept digital audio inputs so you can daisy chain two HDPRO or HD500 and HDPRO without leaving the digital domain.  Use MIDI to get the controls linked so that both units change patches at the same time.

The information above may not be current, and you should direct questions to the current forum or review the manual.