Hello all I hope you're well and can help me with my issue. Thanks in advance your efforts; they are much appreciated.
Settings:
Master volume knob at 50%. I have volume leveled my patches using the mixer. I use parameter exp 1 as a volume pedal. I put the pedal near the end of the chain immediately before the reverb.
The issue:
I physically adjust the parameter pedal to a certain angle which of course sets the current patch volume to a certain level; say 30 degrees degrees on the pedal, which corresponds to 30% of the volume. I then switch to another patch, adjust the volume level for that patch to say, NOT 30% of the pedal and switch back to the original patch.
Here's the rub:
The volume level I had set the original patch at using the exp1 volume pedal just before switching off the patch doesn't default back to the level that corresponds to where I left the pedal immediately before i switched off the patch!
That's the way a real volume pedal works, so what's the rub?
The volume level does not correspond to the physical pedal location either. It seems to set back to some default level (I can't really tell what; soon as i move the pedal it jumps off where it was at).
I am forced to work the pedal up and down to adjust the volume level everytime I switch a patch. I have tried using the channel volume with the pedal but the problem is essentially the same.
What I need:
I need the volume level for the patch to either match where it was immediately before I switched off the patch in question or to match where the pedal currently sits when I switch to a patch. Neither is the case. This is NOT how a real volume pedal works either.
Is there a way to set the parameter pedal to the Master volume perhaps?
Please help!
