pvnisher

Thanks for the replies. Just to be sure I understand, let me see if this makes sense. Keep in mind my current multieffect pedal is a Dod Tec4 that's at least 20 years old, so I'm a bit behind the times... I press "A". I now have footswitches 1-5 to use as single stompboxes/effects, played through a single amp and in a particular order. As I switch between FS1, FS2, FS3, etc, there is no lag or gap. Correct? I press "B". I now have five different stomps, and a different amp and layout. However, when I switched from A to B, there was a small gap in the playback. C, D, are the same as above. The I press the up arrow to change the bank, and now my A, B, C, D are 4 new selections. Basically, there's no delay between FS1 and FS2, but there is a delay between A and B. Is that right?

I've been reading reviews but can't quite tell if the Firehawk can do the specific things I want it to do. The requirements are pretty basic, I just want to be sure. Can it do these things? If it can do the things below, what are the limits on each one? 1) Can I assign any single effect to any footswitch (like stompboxes). Examples would be a crunch on FS1, a distortion on FS2, a modulation on FS3, another distortion on FS4, delay on FS5. 2) Can I stack effects on those footswitches Examples would be crunch,delay, and EQ on FS1, distortion, delay, reverb, flanger on FS2, etc. 3) Can I stack effects with different amp models on any switch? Example are: same as above, but with a different amp model for each effect. 4) Can I switch effects while using looper? Example is lay down a clean section, then overdub a crunch section, then overdub a chorus/distortion section, etc. 5) Is there any delay whatsoever in switching effects/banks or anything? Is the sound output seamless? Thanks!