Murfski

It should be fine. Plenty of people have done this before, HX Effects doesn't need 3A, more like just over 1A, which despite the placarded output of 500mA, can be supplied by using 2 outputs of the Ojai. Here's a previous thread on this topic. You need to run 2 outputs in parallel (ie doubling the Current) so you'll get 9v at 1000mA+. HX Effects input is 9v Centre +ve and a 2.5mm jack. Depending on which cables you use you may need to reverse the polarity. Strymon don't appear to offer a current doubler adapter cable (?), but there are suggestions in the linked thread. Frankly I find it easier to make my own rather than using a selection of cables and adapters, but it does require a very basic understanding and ability/equipment to solder. HTH

Update: CIOKS DC7 works just fine when using 2 outlets in parallel. Preset with max DSP usage and then connected headphones to hopefully simulate max possible power draw. Absolutely no issues, and blissful lack of power supply hum.

Thanks for the reply phil m, I guessed it would be ok but was wondering if recent updates were working the processor harder and hence drawing a bit more current. If you are running off the Ojai it should be fine, I could use three outputs if I run into any issues. I tend to make all my own cables so that would be straightforward. There are so many ways of powering the Stomp, but my current budget power brick isn't isolated and with 4 fuzz pedals, an overdrive, distortion, extra phaser, drum machine and looper it's become noisy. Time for a one box solution and ditch the slightly irritating supplied PSU. Thanks for responding.

I'm looking to power my whole board from just one power supply. CIOKS DC7 looks perfect and has been demonstrated running a Stomp from 2 outlets. However, before ordereing thought I'd ask the collective wisdom if any of the recent updates have increased the start up load and continuous load significantly such that 2 outlets (1320mA) is becoming marginal? Has anyone measured the loads recently and seen an increase over say v2.7? If anyone is having no issues when using a Strymon Ojai (parallel output @ 1000 mA) that would also answer my question. Thanks in advance.