UncleCharlie

Thanks Phil. I appreciate your advice and will look at the level parameter in the output block as well.

Hi, I have recently purchased the POD Go and there doesn't seem to be a basic volume function when using a patch or when switching from one patch to another. You can be playing at reasonable volume with one patch and then switch to another patch and the whole house shakes because of the volume. Totally not acceptable. Is there anything more basic than volume? The solution that I have seen is to go through all of the patches and adjust the channel volume, and/or the FX loop level after initially setting your amp and the master volume of the POD Go at the volume you like. Then saving each patch. This is a very time consuming process and I'm afraid I'm going to spend more time dialing in the POD Go then actually playing guitar. Line 6 should provide specific instructions to address this basic issue and maybe there is but I haven't seen it yet.