Hi, guys.
I got an HX Stomp (love it).
I use footswitch mode and snapshots together (I keep it basically in footswitch mode and use an external footswitch to change snapshots sequentially).
For example, in Snapshot 1 I have a clean amp, in Snapshot 2 I have an edge of breakup drive, and so on.
For the Snapshot 1, I use a more pronounced reverb, and I use Footswich 1 to make the mix go, for example, from 20 to 40. But, for Snapshot 2, this values would be too high.
Is there a way to make one parameter to vary in a certain range when pressing a footswitch (in footswitch mode) while in Snapshot 1, but to vary in a different range in Snapshots 2 and 3, when pressing the same footswitch?
For example, to use Footswitch 1 to make the reverb mix go from 20 to 40 (for example) in Snapshot 1 (and then return to 20 when I press it again), but go from 15 to 30 in Snapshot 2?
I tried the Command Center, but could not figure it out.
Excuse me for my poor english, and thank you in advance.
