Hello,
I just tried to update my POD Go with the 2.0 update, and it won't boot now.
I'm using MacOS.
I plugged my POD Go into the computer, and followed the instructions/prompts and updated POD Go Edit to 2.0 first. Once that completed, it prompted me to back up the Pod GO (which I did), and then prompted me to update the firmware to 2.0. I did that and the POD Go Edit software said that the update was successful, but the POD Go still said "Updating". I waited ~10 minutes, and when it didn't change I rebooted the unit.
After that reboot, it was stuck on the regular splash screen (still stating that it has version 1.40). I rebooted a few times, and disconnected/reconnected the USB cable with no improvement (POD Go Edit says that it's disconnected).
I tried reverting to 1.42 on the computer. Same result. Tried booting the POD Go into Update mode and the screen turns white (as well as down-arrow and D, with red TAP), but the computer still doesn't see it. I tried restoring factory defaults (booting with C and D down), and the screen says that it will reset, but never advances past that message.
So, TL;DR I've tried everything, and it won't boot, and the computer won't detect it.
Please help.
