amcolan1

I figured it out with the morninstart. I added a PC message to automatically go to that preset for both amp channel positions. then a CC message for snapshot one in one position and a cc message for snapshot 2 in the other amp position. working great now.

I have one main preset that is meant for my rhythm and solo tones which is what I use 80% of the time. If I happen to be on another preset and want to jump straight to my solo tone/preset which is 000, I dont want to have to first switch to 000 and then activate my solo. unless theres an easier way to do this that im not thinking of. I want a pretty simple setup. I have basically 4 amp channels that I have set to 4 buttons on the morninstar currently. and each button toggles between that amp channel and a volume boosted version utilizing the 2nd master volume. I basically want to have preset 000 as a global preset that is set as bypassed on snapshot 1 and then acticvating the delay and drive function at the same time I activate the master volume for a solo boost. bottom line I want a way to get all my blocks active and my amp volume boosted all with the push of one button. Hopefully that makes sense. Now if I happen to be on a different preset and I want to get to my solo I then have to swithc presets before I activate my solo boost

So theres no way to recall a preset using the IC functions? is there a way to toggle snapshots using the IC using midi? if not then i may have to just use the morningstar to accomplish all functions with the push of single button. im trying to get all functions done with only one button and not multiple button tap dance

im only referring to the HX. in the command center i can setup functions for the FS or IC. thats what i was referring to.

So i got the toggle for snapshots working using the foot controller switch. One thing im not sure of is setting up the same button to recall preset 000. just incase im on another preset i want that button to bring me back to 000. from what i can see if i used the controller assignment to toggle snapshots then i have to use IC for everything else correct? does it matter which function i choose to setup with IC? am i better off using the footswitch function for the preset recall and then setting up snapshots with IC? or does that not matter?

I appreciate the help but a lot of this is going over my head. I dont see a way in the instant commands to send a PC message. I only see CC or bank PC. Is bank PC correct?

I have the JVM215C. It has midi capability through PC messages. I currently have my morningstar controller set to change between amp channels and master volume settings. im trying to figure out the best way to toggle beween rhythm and solo settings. id like to be able to hit one button to simultaneously activate the delay, a drive block and also change to the other master volume on the amp. and then when im done soloing id like to be able to hit one button to deactivate it all and go back to just the single amp channel with all the effects disengaged. hope that makes sense.

Im not sure if this is possible or not but im trying to set up a single button on my HX stomp to perform multiple functions. id like the following to happen when I push the button. Recall preset 000 on snap shot 1, change marshall JVM amp channel to specified channel. Then when I press it again I want the hx stomp to toggle to snapshot 2 and switch to a different amp channel. Id like this button to be able to toggle between these two states. Is this possible? Any help is greatly appreciated.