kitaristi3

The third picture Is from the command center page after you press the Menu key right after powering on the device. Is it supposed to look different? I've experimented with all the Midi CC, CC Togl, Bank/PC and MMC -controls and options with poor results. I suppose Bank/PC is the solution to my problem but I'll try again tomorrow with the manual;) Cheers!

Hello! Heare are the pics of the preset 01A at power-up. They are from command center and Global settings menus.

Sorry, I' a bit late. I just tried the Disaster Area midi monitor but it's not giving me much. I tried it with 01A preset on my HX. It gave mew some on/off messages once or twice but I haven't gotten anything after several tries. I tried AMP1 withm my Tech Midi Moose pedal. It works like a charm and the programming was a snap. I tried chaining them Moose -->> HX -->> Amp1. The Midi Moose switches patches on Amp1 so the Midi through on HX. Unfortunately the patches on HX do not change with this setup......

Yes, I have MIdi1 which I connected to the Midi out/thtu on the HX.

I'm trying to control AMP1 via HX's Midi Out. The Midi channel on both units is set to 1 and I disabled USB MIDI, MIDI PC RX, MIDI PC TX and Snapshot CC Send. When I choose the channel, boost etc at AMP1 and press, say patch 1 button at the HX nothing happens except that the Amp1 freezes. That means I have to boot it. I tried the same programming move with Tech 21 Midi Moose controlling the Amp1 and it worked like a dream. Blueguitar informs us that if there's too much Midi-information going on you are surely to experience a failure. What's wrong here?